Each kit will come with a Viair 280 Compressor that is 12v. If you have a 6 volt system, you will need either a 12volt battery to run the system or change over your ride to 12 volt. We usually mount them on the opposite side of the master cylinder on the wing under neath the gas tank.This allows the compressor to get air and lesson any noise that can be had with them. The kit also comes with a 2 gallon tank. We usually install the tanks underneath the back seat so they can be hidden. This is not a must as anything can be installed anywhere you would like. An adjustable pressure switch along with a 12v Bosch relay and harness also accompany the kit. This allows you to adjust the speed and consistency of air management system. This switch send a signal to the compressor to come on at a certain PSI so that you always have air in the tank when ever you need it. Its what we call, ON DEMAND. Each kit contain a hardware pack and 1/4" fitting pack. It will also come with an est. 100 feet of 1/4" hose. You might ask, why do we use 1/4 line. One word, LIABILITY. Everybody that is in the mini truck industry, use 3/8" or 1/2" maybe even bigger line to make there vehicle lift fast or even hop. These kit will not take that kind of abuse. If you attempt the parts will fail, so use at your own risk.Now on to the valving.Our 2 valve electric kit . Very similar in characteristics to the manual set up only now, the kit is electrically activated with electric solenoids. Why would you want that? Most people like the cleanliness of no hoses inside the vehicle. This kit rids the hoses from entering the vehicle. Electric solenoid are placed in the front and back of the vehicle and wires are ran to the electrical switches. Some people like the sound they make, other do not. Also, electric systems can be attached to your alarm so they can be lifted from your alarm key fob. Very trick!

Dim lights